Search results

Hello, I have a bathroom floor tile that has lifted up from one side, I can push it down but it springs back up. Flooring was done before we moved into the house, and we found it like this when we moved in. How do I go about fixing this?

Thanks @Madrab , I ordered one of the sets similar to that @HERTS P&D mentioned yesterday which has a box spanner because I think that’s what’s needed in that space. If I do what you suggest, I think I’ll prob have to take both the taps off as they’re attached to each other. Are there any screws...

Tried with a crowfoot spanner and an adjustable basin wrench…the crow foot struggles to get a good grip of the nut, similar with basin wrench. Any other ideas?

Excellent, thank you, will get one of those bath basin/crow foot wrenches, that looks like it will do the job. Those nuts a universal size then? Also, in case the washer is gone (which may be why the issue has now started to show itself), any idea of size of washer? And definitely no kind of...

Thanks @Stuckinarut problem I have is the wrench doesn’t have much space to turn between the tub and the wall

hi all, Have a leaking shower water inlet pipe which I’ve fixed by replacing a 3/4 washer. The issue is that the water from this pipe was leaking down the bath water inlet mechanism and down onto the room below. Now I’ve fixed the source, trying to fix this secondary problem as well as...

The boiler is in the garage, the hot water tank is in the attic

Thanks. I only see one motorised valve in that last diagram, just checking, but are you saying that the last version which allows independent control of hot water and heating would only have one motorised valve?

Ok thanks. Why would finding the other motorised valve help you solve the issue here? Just so I understand what you’re thinking the issue is?

So for a bit of background, this issue started when our house flooded due to a burst frozen pipe in the attic about 5 years ago. The house was renovated, and a lot of the pipework was changed with that (but not the boiler itself). Before the renovation work, we could switch on the heating...

Why do you think we have a c plan?

I’ve had a good look around in the usual places (near water cylinder etc) and I can’t find a wiring centre. Only thing I could find is attached, but it doesn’t look like a standard wiring centre I’ve seen before. Boiler was installed around 20years ago, glowworm hideaway 120b.

Photo of other pipework nearby

No other similar valves. Only other thing coming off the pipework is the circulating pump.

Where would the other one likely be?

Thanks, here is the motorised valve we have. The valve was replaced around 2 years ago due to a fault with it, but this issue present before then.

Hi, I have a system boiler heating and hot water system. Controller/programmer is an ACL lifestyle LP241. This programmer has two channels - heating and hot water. However, they don’t function separately. The central heating does not switch on unless both heating and hot water channels are...

Found the part needed, thank you. Sounds like simpler to just trade in like for like rather than go for a different make?

All the knobs don’t spark when depressed like they usually do. Opened the top of the hob and wiring all seems fine. Most likely it’s the spark generator given all 4 don’t work. Yes I’ve searched online. It’s quite difficult to find the exact same model of spark generator. That’s why I’m...

I have a BOSCH gas hob that has had the spark generator fail and need replacing. Do I need to replace it like for like?