I have 10mm in my house although was put in by a red hot engineer!.You have been asking question everystep of the way.you will allways get different ideas.I have seen issues with copper micro poor but normally poorly fitted
Some people hate ideal boilers some love them etc.
Not having a pop and...
You will get a fitting behind rad if your struggling with angle.Just bring pipes out of a electrical single /double back box not forgetting rubber gromets that fit where pipe comes into box.Leave your self 100/150mm pipe then put a 10 mm elbow on if needed.
You can cut pipe short and fit elbow...
If your living there and no one else is being let loose with a drill you will be fine.Measure where pipes are
Just measure of something thats not moving ie window/ opener,i know this is common sense but dont measure from corner of room .
You dont know if rooms out of square plasterer may have to...
All would probably work,each side of window not ideal think i would keep them together.
I would make runs as short as possible so possibly side of window or as close as to miss future batterns for curtain rails/blinds etc.
You may struggle with angles out of box but you will have enough room...
13 posts and most about a gas nipple.You say you used to fit your own hobs but couldn't tighten a gas nipple.
Guessing you've made a fuss with engineer,the wifes told you stop being a dick.
Youve came on here and been told to stop being a dick
Dont think you will reach dans 37,805 post do you.
Dead rats dont smell pleasant and it lasts a good while(but it is a sweet sickly smell).We phoned local council out and he was pretty good checked drains etc.Baited manholes then came back until bait not taken anymore.
Did the trick.Baits a blue type block.
May be worth contacting council.
You...
When I started old man bought a cheap torch thinking he was helpful. ....
Working upright it was fine,upside down kept going out,still remember the **** taking ,swearing and chucking stuff about like it was yesterday .
Buy a decent one
I shouldnt worry 2 much by the sounds of your attitude.I think the plasterer will be walking off site followed shortly after by the painter when you start telling him how to paint,,,
Its a pain but i would get pipes moved (deeper?)and as said above dig bath into wall.You will have trouble sealing if not.
Maybe fit batterns for the bath to sit on then fill gap but big gaps not ideal.
Depending how the baths been fitted you may be better refitting it when tiling etc.
I normally fit batterns around for bath lip to sit on prevents too much movement.
If baths moving slightly you will never stop it leaking.
check the flexi over flow hose aint leaking they can be swines
I would get some more quotes think there may be a couple of us that haven't quoted :oops:
I would be happy to put diesel in my van and drive 4 hour round trip and quote if you like...