Search results

Hi all, I got called out yesterday to Baxi Solo 3 50 PF. Water circuit and pump fine. Boiler works first time from cold but wont restart 1 minute later if switched off. If it is left running it will heat rads as per normal till preset temp is realised and wont fire up again for approx 6 hours...

I have the following problem with a vokera 14 mynute se boiler. I have sparking at eletrode but no ignition. Gas valve solenoid was buzzing so I replaced gas valve with no success. I then replaced the ignition pcb but still no ignition. Looking at the manual points me towards the high limit...

I am having problems with the rubber sleeve and clamp connections which connect the elbows and flue extensions in the vertical flue installation I am installing to a baxi solo (also applies to baxi systems boilers). They don't offer much grip when fully tightened and pull apart very easily...

Just fitted a pcb to a glow worm micron 50FF due to the following: Fan only starts up when spur fuse is switched off and then switched back on again. This happens even though the boiler control stat is switched off and then everything stops without firing. The led sequence points towards the...

The following problem exists with a Vokera 16e: It wont fire at start up, pump runs, fan runs. When I remove the combustion cover it fires, runs for approx 5-10 seconds and stops firing. It repeats this process continuously while the fan continuously runs. APS tubes are fine and tight...

I have a problem with a Ravenheat primary condensing boiler that fires and stops repeatedly every 5 seconds or so. Has anyone encountered this problem before.

I have a problem with a Baxi Solo 3, that starts and fires fine, but after a couple of minutes fires and stops repeatedly water circulation ok (no air locks, rads heating). PCB replaced. I was wondering could it be the boiler thermistor sensor. Anybody any ideas?