Search results

Spoke to the guy from the website and he said the model number needs part number 9509007 ... so ... ordered this part (on the right) to replace the two that had been installed previously (on the left) still not cheap! with postage and VAT still comes in at £38 ... Landlord is paying so not my...

Thanks for update Flameport ... I looked at that one online too, I am a little unsure what it replaces though. Not sure if you can see from my picture what looks like the Thermostat assembly. Would this just connect across that unit ?

That is what i was proposing to do on Monday morning but just thought I would see if anyone had some knowledge or experience on this subject. I don't normally get involved with storage heaters much but this customer is on my doorstep.

Hi all, was wondering if anyone with storage heater experience could advise if this cut out assembly is a replacement for the two that I have on a customers heater. The heater is a Sector model number STHS330A 3.4kw ... I believe the Dimplex equivalent model is a XLS24N Picture one is of the...

You are completely correct RF but it is bad practice and as most showers are rated IPX4 it would seem that some accessories would have a higher rating and be subject to less water spray. I would also note that shower units should not have their casing altered to accept a cable entry which could...

I agree.

my sentiments exactly!

going back tomorrow to double check measurements. Forgot to take a reading when first on site as I thought this would be straight forward common sense and would be given permission to go ahead with moving it. Can't believe this was not picked up on the original EICR (not done by me I must add)

going back to site tomorrow to double check ceiling height and carry out remedial work. The shower head is within 6 inches of isolator. Even if switch was above 2.25m and shower head fitted at ceiling level it would still comply according to two Scheme providers. I am making sure I am not going...

Just want an opinion on this guys. I know what I would do but it seems the NIC think it's acceptable ... I have posted this on another forum but wanted to get a wider opinion.

This is a good example (if I say so myself)

That's correct and now Mitie are about to make a load of ETI & PAT engineers Redundant !!! Thanks Mitie :evil:

Ref "C" on tray/wood/masonary or "100" "101" if Thermal Ins

Ok Ok maybe everyone that posts on this Forum should have thick skin and not be afraid of the odd insult. nuff said from me! I will keep reading the Forum with interest.