Search results

Just one question more on this topic. If I add sentinel to clear/remove the sludge build up might it come straight out of the vent pipe?

Thanks John D for your detailed explanation. Off to the plumbers merchant in the morning to get some sentinel x400

Hi, Can anyone help, the vent pipe above my f & e tank is letting boiling water into the f&e tank and oveflowing at a high rate. As a matter of course I have changed the p2 float valve to no avail. as soon as the c/h is switched on the water commeth. This does not happen when the h/w is on and...

This will probably sound stupid but hey ho. I am trying to replace a washer on a tap and cannot loosen the valve section without the tap turning. I have tried a towel round it with a set of grips but it still turns (ideally need three hands) any suggestions apart from removing the tap from the...

sorry yall, potterton profile

Hi, I had to change a rad valve due to a crack. I drained down the system, replaced the valve opened the bleed valves and filled up the system. Once filled then switched on the hw & ch the boiler then fired up. Approx 3 hours later the hw was only luke warm when it used to be boiling hot. The...

Hi, When the central heating is on and the hw off the rads are all hot, as should be. When the hw comes on with the ch the hw is hot and the rads loose there temp. Any ideas?? This is a vented system with a three port valve.

No.. the one I am looking for is a single handle that seems to slot in both sides (the circular holes) at the same time thus allowing you to lift it. Thanks

Can anyone help me, I am trying to find where I can buy a manhole /Inspection cover lifting tool. I do have the small keys that you insert and turn, however, the one I am trying to locate is for the covers that have two round holes at either end approx 7cm wide. The tool locates both and lifts...

Hi, please forgive my naivety but when installing a bath, should you need to cut the height of a front panel or should the bath be set to the panel height so not height cut is needed? Hope this make some sort of sense. Last question, when the plasticish panel is in place it seems quite flimsy...

should the plastic pipe that connects the overflow to the waste be siliconed or solvent/cemented or nothing?

Yes, did tighten the leg bolts and used a spanner to make sure tight. My only concern is that the legs that fit into there "holders" only seem to go 1/2 way down which are then secured with a form of grub screw. Surley these legs should go all the way in as the weight of the water will force the...

Yep, a cheapn B&Q job

yes both fitted

Yes,with cold water up to the overflow (also to check for leaks)

When I installed my bath the legs were firmly fitted and adjusted to the right height. Now the silicon keeps splitting when the bath is filled and someone is in it. Prior to siliconing it I did fill the bath. Any ideas why this is happening and what did i do wrong??

No Luton, Beds

Luton, Beds. Tried; plumb centre, city plumbing, and gibbs and dandy all closed. screwfix..no chance.

perfect, its for sure the sponge type, where can i get this type today?

How right you are.... any ideas whos open on Sunday?