Search results

hi, firstly. i am qualified to install unvented but have never been asked to do one before. old system is y plan so can i simply add a zone valve in the flow to the unvented cylinder? also the cylinder stat doesn't seem to have a click on/off point as it only goes from 60 - 90 degreees so will...

oh, what would need replacing then? the diverter valve? does this old model have a diverter or is that the servo valve? are they the same thing?

ok will do, thanks mate.

can't rememebr, am not at the shop today,its about 15 yrs old though.

hi, i have a 282e which is fine for hot water but only fan and pump fire up when ch is called,any ideas? also where can i download a manula for it? vallant only post them out which is slow, cheers.

HI, I HAVE A QUANTITY OF THESE CERAMIC FUSE HOLDERS MOSTLY WITH FUSES IN THEM, ARE THEY WORTH ANYTHING? SHALL I CARBOOT THEM OR BIN THEM? CHEERS. [email protected]

hi again, the boiler is an rf wallhung combi and the valve is gm-7521-3500 maclarenline. does this help?

can't remember the number, i think it was a 30?

hi, does anyone know where i can get a new or used maclarenline gas valve for an old glowworm spacesaver boiler? i have been told they are obsolete but i though i'd ask you guys.cheers.

hi, have read your posts on this subject and it's obvious you are experienced, can i email you - or you me to answer some questions before i start my project? cheers ________________________ moderator email address removed, please see 14a

THANKS FOR THE INPUT KEV - HOW'S THINGS IN AFGHANISTAN?

hi i've got a leisure rangemaster 110 double oven which intermittently won't light the main flame, it just stays on low flame all the time, is this the heat sensor or just a blockage somewhere in the valve? any help appreciated:- ____________________________ Moderator email address...

hi, i have a vokera maxin 24e combi and the reset light keeps coming on sometimes within seconds, sometimes after a minute when filling bath or sometimes not at all, same with c/h as with dhw does anyone have a troubleshooting guide for one? all i have is the customer care guide, no technical...

hi, can anyone tell me what type of waste pipe to use for the outfeed from a macerator? i was under the impression that a single length of special flexible pipe made for the job was available but someone has told me to use standard rigid 1 1/2 " waste pipe and joints, won't the pressure force...

thanks very much for your help/info much appreciated

hi guys, i have just fitted a shower valve which is compatible for any system including combis, do i need to fit anything else? check valves? to stop the cold flowing through and down the hot pipe etc. thanks.