Search results

  1. M

    Firebird flue problem

    i'm trying to clean the flue on a condensing Environmax after the condensate pipe blocked. The boiler soots up immediately. I'm struggling to see how to clean the flue/ condesate pathways? Anyone seen this? I'm thinking I may need to remove the boiler and pressure clean it somehow. Thanks.
  2. M

    oil burner problem..well panic!

    Thanks Bob,your help and thoughts much appreciated. It's running fine at the moment,having a day or two off before committing any more time/ money,it's a character flaw really,I started life as a mechanical engineering technician and the drive to always fix not replace where possible is hard to...
  3. M

    oil burner problem..well panic!

    Thanks again oilhead. I will take the first seized pump back to see what the warranty policy is,but Riello are understandably wary about warranty claims. I think I'll run up the motor with no pump to see if it gets hot on its own,but there's no load so that isn't really a good test. Might get a...
  4. M

    oil burner problem..well panic!

    Thanks for taking the time oilhead. The box is marked B 10, I'm guessing this is not the same as "bio" ,I read that bio fuel can damage regular pumps,but our fuel is just regular heating oil. 1 pipe system,there was muck in the line ,but ran it from the tank until clean then installed two of the...
  5. M

    oil burner problem..well panic!

    Hope someone can help,I've got a burner problem I've never seen.Old camray quartet,Rielio burner,seems to have had multiple faults.Conrol box burnt out-wisps of smoke,replaced it and base plate. Capacitor low value on motor,replaced. Water in oil tank,drained and tested clear with paste. 2...
  6. M

    Moving a consumer unit.

    I need our ancient fuse wire consumer unit upgraded and moved to a more accessible place as my wife can no longer get up steps following a car accident. I asked an electrician to look at it but he was reluctant to move it from it's current location against the ceiling. The wires above the unit...
  7. M

    Wallstar oil line bubble,not the usual!

    Thanks oilhead.I'll do those checks. I diod stand and wait watching the clear flexi for a while,both running and idling,not a bubble.I'm thinkling pump. Cheers.
  8. M

    Wallstar oil line bubble,not the usual!

    Yep. HRM say the pump sealaround the shaft is sometimes a problem.Not like a gas leak where you can detect it with a spray or whatever.Will have to try the pump,just ;like to know rather than guessing. Thanks for replying oilhead.
  9. M

    Wallstar oil line bubble,not the usual!

    There is a large,10" or more bubble in the clear flexi,if it is bled out completely it reappears in a couple of days or so,rep;laced flexi,remade all joints in the line,filters ok,replaced check valve. In operation bits of bubble are being sucked in to the burner every now and then,I've watched...
  10. M

    Douglas James Shower pod valve replacement.

    Yea,nothing to lose really,gotta come out one way or another,really,really not wanting to remove the pod! Thanks for the help.
  11. M

    Douglas James Shower pod valve replacement.

    Thanks,I've found the videos,but it is an earlier valve I think.I think I will just have to get a bit agricultural with it. Try 2 hammers either side of the knob maybe,like releasing a taper joint on a car suspension,or just saw the knob off.darent tug too hard,there is too much flex in the...
  12. M

    Douglas James Shower pod valve replacement.

    I have a shower valve to change on a Douglas James shower pod,aboiut 10- yrs old.The valve lhas two concentric knobs,each with a "rod" sticking out to give purchase. I think the small knob should come off after unscrewing the knob and the allen screw the knob screws onto,but it is stuck solid. I...
  13. M

    Can I strip the bottom row of slates?

    Thanks.Great site.Very helpful.
  14. M

    Can I strip the bottom row of slates?

    Thanks,I've checked out the Hall clips which are a clever solution,and there are some other clips called Jennys which work on a different principal.I'm an experienced joiner so I'll give it a go. Just never had this particular job before.
  15. M

    Can I strip the bottom row of slates?

    OK. Thanks.Doesnt sound easy.
  16. M

    Can I strip the bottom row of slates?

    Yep,real slate.Old roof.
  17. M

    Can I strip the bottom row of slates?

    I have some fascia and cast iron gutter to replace on a big farmhouse,I'm bound to need to get at the rafters somewhere,is it possible to strip the bottom couple of courses or so of slates to carry out repairs/add breathable felt etc?
  18. M

    Best trade vacuum cleaner?

    Thanks j&K I am a big fan of metabo - after sales second to none,so I'll be checking them out. Don't do any site work these days thank heavens,too many cold,muddy,dark Januaries!
  19. M

    Best trade vacuum cleaner?

    Thanks everyone! Just what I needed,only concern with a Henry is if it gets a bit of damp as I'm hoovering up,not a puddle or anything,but you know how it is sometimes!
Back
Top