Search results

the oddest thing just happened.....I switched off the boiler for about an hour and a half and i have just switched it back on and now everything is working. I am sure this will happen again so i have called the corgi guy back to come back and check it out again.

I have recently had a new boiler installed by a Corgi registered engineer and its been working fine for the last 4 weeks. This evening I noticed that the flat was a litle cooler than normal and went to check that the boiler was working. The blue light was flashing, which according to the...

I also have one rad not working whilst others are fine. It has been removed and flushed out but still doesn't work. I was told that I would need to replace that rad for a new one.

I am having the same problem as you with regards to the banging, but this only happens when I put my programmer on "1 hour"...i.e to get HW or CH for 1 hour. However since this began last sunday I have found that I can't get HW and CH at the same time...although the pipes in the cupboard for...

I am assuming that the red box thingy in the cupboard which is very hot and has marks on it indicating highest to lowest ( i think it is the pressurre indicator) is the pump....assuming that this is true, there is nothing else above it. The only other things in the cupboard are 4 knobs...

what is fan running boiler?

just tried again...switching on the HW causes the boiler to ignite and work again with no banging but switching on the CH is not causing the boiler to do anything so basically, I am without heat. Any ideas on this....

Upon needing more hot water this morning, I switched on the boiler and noticed the following - The boiler would switch on as usual and after 30 secs you start to hear banging inside the boiler, then the ignited pilot light would return to a small flame and the boiler would switch off (as if I...