Search results

I'm sure there are many threads on this subject, but none appear to answer my question. Apologies for any duplication. I have the above mid position valve fitted into my ‘Y’ plan CH system. It was fitted approx 5 years ago and has operated impeccably until very recently. I can get a...

I'm about to fit a pair of 4 foot wide french doors in an existing wall. The opening will be created using a diamond cutter and a lintel of the correct spec will be used to support brickwork above. I intend to fit proprietry plastic insulated closers in the horizontal wall sections (building...

I am replacing my gas oven with an electric oven. The electrics are sorted, but I assume the gas oven is connected to its pipework by the normal type of flexible hose. When I disconnect it and the valve on the end of the pipe 'self seals' as it's supposed to, is this enough on its own or do I...

I have a seperate circuit for my hob and oven. I believe the wiring on each to be 6mm2 (measured as 7 strands of copper wire approx 1mm dia for each cable) My questions have arisen as I am about to replace the oven and want to make sure all is OK: 1) I have no problems. The ceramic hob works...

An easy one I hope!! My view is... When a boiler reaches its own inernal temperature limit (set by the burner potentiometer?- comments welcome), the boiler shuts down even if the room stat or cylinder stat are calling for heat. The pump continues to circulate water and when the temperature...

My boiler gets it's supply from the programmer (L, N, E). so power for HW and CH curcuits! Boiler will cutout without warning although there is still demand for HW /CH. However, it will only run for 4 minutes if demand for HW only, but if demand for CH and HW or CH only, boiler can run up to...

Firstly, can anyone tell what this is and what it's function is? Secondly, What are symptoms of it's failure? Thirdly and lastly, how easy are they to change (on an Ideal Classic NF60 Boiler)? Thanks

Help please. I have an Ideal Classic HF60 boiler (not condensing or combi on Y plan system) inherited with the house, probably maximun 10 years old that has been reliable and appears to work fine when it does, but intermittantly I notice there is demand for HW/CH (neon on on PCB), but the...

Help please. I have an Ideal Classic HF60 boiler (not condensing or combi on Y plan system) inherited with the house, probably maximun 10 years old that has been reliable and appears to work fine when it does, but intermittantly I notice there is demand for HW/CH (neon on on PCB), but the...