Search results

Hi can anyone help? I live in a flat which has central heating and hot water fed via one main boiler for the block. Lived here 2 years now and the water is always really hot and we could have several showers out of our tank or hat water. For the past month now we can have 1 hot shower and the...

Hi all, Just a quick question as i don't have any regs to hand. I have a mains voltage fan in Zone 1 of the bathroom which is obviously a no no. If you were to install the circuit on an RCD is this acceptable.?? Thanks

Anyone know where i can get my key transponder for mk4 golf programmed in london (other than VW) Thanks

Hello, Ok well i have a leaky bath/shower. It was fitted 2 years ago but never sealed very well around the rim of the bath. I have tried to re silicone it twice to stop it but works for a couple of months and then a dark patch starts to appear under the silicone and it starts leaking again. I...

Hello all, I have a pump on my hot water as the pressure is poor. Basically Its been making a howling noise off and on for a while now, but i have now noticed today that its not turning off when you turn the tap off. I have checked all taps and none are on even slightly. I think it must...

Hi, I think i may have bought a cat D car. Can anyone tell me where on the V5 log book where i will be able to tell. Thanks

Ok whilst im on here i might as well sort all my diy problems. I changed our cold water tank last summer. It was an old metal one that had completly rusted out. All when to plan no problems. Great, well until we started using the hot water. The hot water is on its own electric pump as there...

Hello, I have just changed an immersion heater element. It's an 11 inch one that goes in the bottom of the cylinder. All went to plan until i filled it back up. Its dripping quite a lot. I have used the supplied gasket that comes with the element and i didn't over tighten it (although i...

Hi, I have a toilet cistern that is a B&Q special thats about 18 months old. Its filling up really slowly. Its nothing to do wtih the float as i've tried adjusting this. Basically the water is coming out of a pin hole in the top of the mechanism which obviously isn't correct. (Its a push...

I was just adjusting the spring on my garage door but stupidly turned it the wrong way so its come of the main shaft. stupid. :oops: I haven't lost the tension as i still have the spanner holding it in place. How do I get it back on the main shaft? Anyone know? Thanks

Hi all. I\\\'ve got a glow worm fuel saver 45F. Having problems with the gas valve. Basically when the boiler fires up the gas valve opens as it should and ignites. The only problem is the gas valve continuously tries to open and close at the speed of light. From what i have tested the voltage...