Search results

I am fitting a woodburning stove and stove pipe to an existing twin wall flue that comes down through the ceiling. The twin wall coming down through the ceiling is supported by the rafters in the loft(bungalow). It says in the regs that the Stove should not support the weight of the flue, i...

The water in pump on a Candy CDI 1012/1-80 rattles when it pump water in. It bounces about and not much water gets into the dishwasher. The arms dont spin due to lack of water coming in. How do i test the pump?

I am thinking of getting a wood burning stove installed. The Selkirk twin wall installation guide says i need to have 2.3m above the gutters if the roof is 45deg so that the top of chimney is horizontally 2.3m from the roof. Is this required in practise, 2.3m seems very high??

Selkirk say that the twin wall flue should extend 2.3m above the guttering to give 2.3m distance from the roof surface, if the roof is 45deg slope. My neighbor has a boiler outlet coming through the roof which is only 1m and the roof is 45deg, so it can only be 1m from the roof surface. What is...

Is it possible to replace the door seal on a Candy CDI 1012/1-80 Dishwasher? The seal that goes around the door, not the bottom seal.

I am fitting a log burner with twin wall flue. If i have 1m vertical from top of the stove, then horizontal through brick cavity outside wall, then 3m vertical on the outside, will the horizontal section affect the draw up the chimney? Or should i go through wall at 45deg?

If i put my meter across Neutral and earth with the mains switched on the meter fluctuates between short circuit and hi resistance. If i measure between Live and earth i get constant 240Vac. If i turn off the mains i dont get a short between Neutral and earth. What could be causing this, and...

I have a Potterton Profile 60E with fanned flue. The old fan works ok, the pressure switch is new. On startup the fan runs, but there is not enough pressure going up through the heat exchanger and up the venturi to operate pressure switch. If i blow up the tube to the pressure switch the switch...

Hi Does anyone have the wiring diagram for a Potterton Hot Water tank themostat, type PTT2.

Hi I have Potterton 60e, on switch on the fan starts ok but the pressure switch is not switching to start gas and light pilot. Both air pipes are ok, the sealing of the boiler seems ok. If i force the air pressure switch the boiler starts ok. Is the problem lack of sealing to the boiler...