Search results

  1. N

    Indesit WI121 - dial keeps spinning

    why did belt come off?maybe bearing gone and has damage done to heater?
  2. N

    ecoflam monoflame burner

    yes. is it the flue that is blocked?
  3. N

    ecoflam monoflame burner

    it ignites and runs until the thermostat cuts it out then when it tries to fire again it does not ignite and goes to lockout
  4. N

    ecoflam monoflame burner

    `yes it tries to fire up again and then goes to lockout
  5. N

    ecoflam monoflame burner

    this burner was just serviced but now it works cuts ouy when temp reached but cant start again oil ok .is this the electrodes that are not set correctly? thanks
  6. N

    clyde boiler/rielloG3B burner

    hi this boiler/burner i have just serviced but can not seem to analysis right .the co2 reading is 7/8 at best with the oil pressure 8 to 10 .i have tried adjusting the air but to no avail .it burns kerosene and i know the top pressure should only be 10 bar .what can i do to sort this out? thanks.
  7. N

    earthing

    but is it dangerous if not done as back of cooker is earthed any way?
  8. N

    earthing

    is it ok to earth a cooker without using a sleeve over earth as the back of cooker is earthed anyway?
  9. N

    Smeg DWI710 Dishwasher problem

    i think the you have a leak (flood protection system activated) .you will have to check underneath the dishwasher. good luck
  10. N

    Noisy spin cycle - bearings ?

    yes more than likley bearings how to check? open door and hold outer drum steady then see if inner drum rocks up and down independantly if so bearing gone.not an easy job is gone. hope this helps.
  11. N

    whirlpool dishwasher 6830, wont run

    check to see if you have a leak? /
  12. N

    boshe wfg2020 won't spin

    belt ,motor,or motor brushes?
  13. N

    hoover 1100 stops mid cycle

    check thermostats and element?
  14. N

    Indescit WD12 - Water pump or PCB

    cleaning brushes probably wont work you will prob need to replace them.
  15. N

    Hoover WDM120 - Final spin cycle doesn't drain machine

    check pump to see if fins are still on pump shaft or if broken off?or see if pump working?
  16. N

    Hotpoint Dishwasher DWF50 Safety float switch

    should be normally open .butcertain terminals should only fit certain terminals!
  17. N

    adg 7540 dishwasher whirlpool

    ok thanks
  18. N

    adg 7540 dishwasher whirlpool

    something must have punctured diaphram from sump.tried to bypass switch but still no look.
  19. N

    adg 7540 dishwasher whirlpool

    tried that no good.diaphram switch wet .what you think?
  20. N

    adg 7540 dishwasher whirlpool

    my dishwasher pumps out ,fills, then stops,start button flashes 6 times. any ideas/
Back
Top