Search results

Hi all I have a worcester 24 cdi rsf boiler. When turning on hot water tap the hot water light is lit but flame light is not, after a few seconds the radiator light starts flashing fast, tried reset button no change. turned off then on by mains switch and all was well the boiler fired up and...

thanks stevethespreader if thats all the math is then theres no problem there. i am still employed at the moment. i have contacted many several colleges and courses there dont start until september, there all fully booked. so my only option is to pay for it and hopefully get my money back...

Thanks for the replys. I have not made my mind up yet which way to go either will suit me. Plumbing is looking promising, but i am worried about any math involved as its a long time since i went to school. any info of what this course entails in the math department? if I did go with plumbing it...

Hi all hope this is the right section for this post, if not apologies. I am a 45 year old due to be made redundant from the chemical industry soon and would like some info on going self employed. I have decided to take a city and guilds in plastering or plumbing 6217 and was wandering which...

Thanks for the info, much appreciated. Regards

This circuit will be protected by the RCD at the consumer unit so will this be ok to bury the cable in plastic trunking then plaster over it? The cable from the switch to worktop is already protected with metal capping, this was done by a Electrician a few years ago. Below the worktop to...

I am moving my electric cooker about 4 foot from where it is origionally. At the moment the feed to the cooker is direct to the CCU using 6mm. but behind one of my kitchen units. I want to run a new length of 6mm cable from CCU vertically and then once under the work surface, horizontally to a...

adding a cooker connector to a circuit

thanks mate, yes it does work on a frequency of 50 hz. cheers

Hi I am looking at buying a smd workstation from ebay its input voltage is 220 volts 175 watts. would this be ok to use on the uk supply 240 / 230 volts. thanks

Ok checked the solenoids on the gas valve, got a reading below 100 ohms. I decided to check with another multimeter and found one of the solenoids open circuit. Seems my fluke meter was a bit sensitive. So that looks to be the problem. I have a corgi man coming out tomorrow. Hi technical...

Hi all got a problem with my combi. getting no flame, i've got a slow flashing radiator light on the front of the boiler, ignition is working getting a good spark. I have found the installation and servicing manual and gone through the procedure but i am not sure at this part, it states remove...

Checked with neighbours, the side where water is coming from, there garden is higher than mine but towards the middle its about the same level and they have problem with surface water there. We live in semi- detached houses so 2 drains to a house, cant see any leaks. Its just a pity i cant get...

Ok i have decided to dig another soakaway up top end of garden. 5 x 3 deep this filled up 18 inches of water after 3 days, but upto now it hasnt filled up no more. Im going to fill this hole with 20mm pea shingle, this soakaway is near a lot of conifers so hopefuklly this will soak most of the...

ok , had a word with neighbour, he was very good about it actually, couldn't find any cemented drain on his end. could be pond but he said its a couple of feet deep. if i could just find the end then prob solved. this drain though is 1 foot into the clay barrier, is there a reason for this...

thanks for reply OLD haven't had time to talk to him yet, bin at work and hes away for a few days. but i do know that the land drain which is only a 3 inch wide clay pipe is nowhere near his drain. this pipe is flush in his rockery and has been blocked off. is this allowed. it could be an old...

hi all my garden is water logged about 2 inches of water. it was 8 inches a few year ago when we had that downpour so you can imagine the drainage problem i have. my garden is lowest about a foot lower than our neighbours both sides. i decided to dig a soakaway, i got 3 foot down and noticed...

thanks clf-gas

Hi all im having a slight problem with my combi. i haven't used the central heating all week and have noticed that the pressure gauge has almost gone to 2bar, i have noticed this in the past but have just used the the pressure control to flush it outside until i got back to 1 bar, it looks like...