Search results

Hi, I often find myself needing to periodically 'shut-off' all flow to radiators on the top floor of my house during the daytime (to save money when lodgers are out) but I will often want the CH still flowing on the lower and middle floors. It is a real pain to constantly turn off-and-on the...

Hi there, I have a mixer-shower fed via. a double-impeller pump receiving hot water from a cylinder (open-vented) and cold water from a feeder tank which also feeds the cylinder. The pump is level with the bottom of the cylinder, about 3m below the feeder tank. The pump was installed...

I am about to hang a 1200x700 K2 radiator to a skimmed brick wall. The skirting is very high (275mm high by 40mm at the widest part) and I have been told to allow at least 25mm clearance from the skirting-top to the radiator. Can a rad. be too high from the floor? The top will be 1m from...

I am replacing a bottom-entry inlet to a low-level toilet and no matter how carefully I tighten the external white-plastic nut I always get a leaky joint! The inlet came with a conical rubber washer to be placed inside the cistern (cone-side down), but I have my doubts as to how effective this...