Search results

Will do :) Ps.. whats a typical trade price ...

Hi gigz That will be my first point of call then, Looks like not much change out of £100 :( Thanks :)

Hi All Dreaded 168 error Hot water on demand is fine and works all day :) Time of year again when central heating is put back into use and all is not well With the CH dial set to 50 to 60 degrees the boiler will kick in when the wall thermostat demands it but will then cut out after a few...

I Had a gas meter replaced some years ago and the meter read 2 units at start Then they came and read it after 3 months and i received a bill of £2000 I Tried to tell them that a)It was not a chip shop b) Looking at my previous 3 years bills you can see i do not use that much gas For...

No Problem Just modify and i can use either compresion fit or pushfit :!: You can make life as easy or as hard as you like, well sometimes And pushfits were made to make life easy and remove you of money

Anyone had any bad experience with copper pushfits and central heating systems or thumbs UP :wink:

so You would prefer (Better performance) to rip out Isolate Valve 3 Stick in the ABV in it place I'm easy and you guys have done it more often than me All i have to do is get 3 elbows and reducer to bring it down to 15mm The only reason i chose that position was looking at boiler...

Here next weeks project showing 3 port mid position valve Any problems with this speak now or forever hold your piece 8)

It is getting late Yes i was going to slip in the auto by pass after the pump as the diagram shows then next week slip in a 3 port valve so i can eventually get some control with what i want I Hope doing as the diagram and closing valve 3 should take me to the next level of this project...

Sorry Dan you have lost me now You obviously don't mean the Automatic bypass valve :?: Feed me a little more info and i might just catch up with you :wink:

Yes but no but :roll: Local merchants did not have one in stock but did have right angled version which means a bit of pipe work but nothing serious I'm easy all the info i find around shows it fitted just after the pump Thinking as it is 22mm go with the flow instead of adapting to...

Dear all Going to fit Automatic bypass valve tomoz as show below Will it be OK to shut Gate valve 3 after install

Good point :roll: Yes shall rectify that to keep Mr Honeywell happy

Dan Don't care what the locals say your a good egg :D In brief does port "A" go to the top pipe feed to the Hot water storage or to the bottom pipe Plus do i have to stop using one of the 2 pipes as it looks like it defeats the object of the 3 way valve I do plan to fit the...

How about this -------------- Kevin

She (the boiler) is working a treat I Have a question about about 3 way valve Can you buy different arrangements Like below as type 2 would save me a lot of pipework issues From previous drawings i want to T it below the pump and into the feed to the hot water tank Was not sure...

WATCH MY LIPS :wink: It is fully open as i was told earlier BUT As a few comments above make you stop and think when we are talking about hot water and gas you cannot be to careful and this area of work should be given respect Hope you can show me some respect in the future as i do...

So As the system is layed out at present it will work safely but needs an upgrade :?: Back to my question further up the tree does that valve need to be open or closed :?:

Guys Modified picture above to show Storage tank fed from tank in the attic Hope this clears some grey areas

your getting me worried Can anyone explain why my yearly BG inspection on the central heating is always a pass but not to current standards ?? :shock: Is someone giving me duff advice or is BG ripping me off and should see them in court on safety grounds All i can say is arhhh :idea...