Search results

Just a quick re visit to the thread .Ive replaced the faulty relay and fuse ....after doing the brushes . All back together, power it up and.......flashing rinse lamp....... :evil: Whip the motor out to check the brushes are seated and lo and behold one of the spade connectors on the...

Another Post to say thanks for this thread. Not repaired it yet ,all the same symptoms as the other complainants ,so I'm confident a new fuse and relay from Farnells will sort the problem. Already changed out the brushes as that was my first port of call. Top work folks

I used the holycroft for the trial period and found it to be pretty good,I then bought a megger mft 1503 and managed to get a good deal on the meggar powersuite pro software ,which can be used on a palm reader,or laptop,and the test results can be bluetoothed from the tester staight to the...

They have...sheet of plasterboard,starett cutter and a short piece of 50mm batten.,and some poly filla :lol:

But whitgum never said pop to the hardware shop for a compression cap......did he. :roll:

Thats excactly what I did. The neutral is common at all points,so It really didnt matter where i picked it up from. I originally had the pump running from the wiring centre but wasnt sure whether the pump would still over-run. pah...central heating wiring its a doddle :lol:

Thanks for that gasman...just finished wiring in the ufh manifold too,and its all working a treat. I had it all sussed ,except for the additional swl/pump overun terminals on the boiler,that the honewell diag didnt show. I have the full wiring diag. for wiring up an ufh system if anyone...

Can any of you electrical /plumbing chaps help me out,I`ve had to convert my y plan to s plan to add an additional zone for an underfloor heating system(dont get me started on that particular project :evil: ) heres my trouble....where do I pick up the switched supply to the boiler panel...

oops should have been my own thread ..sorry

Thats exactly what I`ve fitted , nice tidy package,built in Grundfos pump,flow and return temp. gauges, flow/mix valve ,over temp cut out etc. I`ll post up a pic tommorrow. I fitted a honeywell auto bypass valve between the flow and return.It`s just this mixing of the two types of control I`m...

Firstly hello . Hate to start DIYnot forum life with a question,but needs must. Can any plumbers help me with a problem I have .I have recently installed an underfloor heating system to the ground floor extension of my house (approx 45m2) The manufacturers instructions state that it can be...