Search results

Hello, I have a glowworm 30ci combi boiler which was serviced a couple of months ago. Its operating pressure is 1.1 bar. Just recently it's started to lose pressure. Every 3 or 4 days i've had to open the filling loop. I was fearing the worst that there was a leak under the floor somewhere but...

Hello, I've just bought a house fitted with a glow worm 30ci combi. I'm having problems with the hot water. When I turn on the tap it takes forever to get warm water through. Even when I only slightly open the tap to reduce the flow rate. When the water eventually warms up and i increase the...

Hi, Can anyone help diagnose the problem with my year 2000 1.8i 16v picasso please? the engine is misfiring through all gears and on tick over really struggling to run. Therefore, i fitted a new fuel filter and a new set of plugs. Took it for a spin and it's still the same. I took the...

Hi all. Is it OK to position a double 13 amp socket below worksurface level in the kitchen and get power to this by running a spur from the cooker socket. I'm fitting a built in single oven (1.85Kw) and also need power to gas hob for the ignitor. Thanks in advance.

Hi, can anyone advise what cable to buy to wire a drayton combi stat to a Biasi M96 32S condensing combi. Thanks in advance.

Hi all, I've just moved a radiator in my house of which the flow and return pipes were bonded to the gas pipe directly below the bolier. As the flow and return pipes are now no-where near the gas pipe i have removed the bonding. Is this ok (safe). I'm having a new boiler fitted in a couple of...

Just purchased a new 2way 2gang switch, £2.29 from wickes, very nice indeed, however, it's different to the switch I want to replace. Pls help. My current setup is, i have a 2 gang switch, one controls the kitchen light which also has another switch on the circuit, the other switch controls...

Hi everyone. Been considering a change of trade for a couple of years now and think plumbing/heating/gas fitting etc would float my boat. Currently a mechanical engineer/toolmaker. Applied to my local college last year and most courses on day release require you to be working in the trade in...