Search results

thanks for that.. will that work even though i have the same pressure of water on both the hot and cold at the moment.. thanks

Hi. looking for some help. I have replaced a plastic 10mm to 22mm connector that goes the immersion heater. The procedure I use is below. 1. turned stock cock off. 2. used a hose pipe to empty the cylinder connected to the drain tap on bottom of immersion heater. 3. replaced the leaking...

doesnt need scrapping as mostly all the parts inside are less than 2 years old. only parts not changed are a couple of thermistors and the reversing valve.

Hi, I have lost my troubleshooting manual wondering if you can help. I am only getting luke warm water unless the tap is closed so only a small amount of water is flowing it get hotter. The ch pump is running ok when water on, fan is on, burner is on. Everything to me looks as it should...