• Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.

tap connector

  1. Z

    Mixer tap hot/cold connections

    Hello, I have recently installed a mixer tap + shower head set to a new bath. During the installation I had a few issues and before I fix everything finally I wanted to check I wasn't locking in any future problems. The issue stemmed from the photos/instructions not matching up with how the...
  2. B

    Improving hot water pressure for mixer tap

    Hello everyone. This is my first post on the forum after much lurking. I have very low hot water pressure in my upstairs basin mixer tap. Being in a maisonette there is hardly any head height from the tank (about 0.8 metres). However there is decent enough flow from the bath tap (separate hot &...
  3. A

    Connecting tap tails to isolation valve

    Trying to install a tap in my kitchen I'm a complete DIY Novice, I've cut the copper pipes and fitted isolation valves on. The tap tails I got with the tap are 400mm in length which are way too big, smallest I can find is 300mm so I went and got them but then realised I couldn't fit them onto...
  4. J

    Install 3 way water filter tap

    Hi I just purchased a 3 way tap that came with 1/2" flexi hoses for each of the 3 holes. 1 hose is for the hot water and 1 is for the cold water. The 3rd one is for the filtered water. I am using an undersink water filter system that connects to a tap via a 1/4" plastic tubing. How on earth do...
  5. flobadober

    How to connect female flexible tap hose to polyplumb

    Hello. I've a tap from B&Q which has a flexible hose with a female 3/4" or 19mm (I think) end. I'm using the polyplumb push-fit system so the plastic pipes are 15mm. I've attached polyplumb 19mm appliance valve onto the pipes. They don't fit. Yeah, I should have checked first, ah well :( Is...
Back
Top