window frame

  1. Jeff543

    Rotted front window temporary interim solution?

    Our big front window-frame is decades old and is rotted. Until i get a company in to install a new window, how can i cover this rot up in bottom right-hand corner? Thanks.
  2. D

    Rotten Wood Next To Window Frame

    Please can you tell me what I should do to fix this rotten wood next to the window frame. Should I add wood filler? Or remove the rotten wood and fill with cement? Or something else? Thank you for your help.
  3. P

    Dpc around window

    Thank you so much for reading this - please help! The DPC around my bathroom window is shoddy and there's a big gap between the metal lintel and the aerated block. I'm planning to stick Gorrila waterproof patch and seal tape to the window frame and dpc on the sides of the frame and the bottom...
  4. A

    Window frame gap needs closing - what's the best way?

    I've a window with a gap around the frame in one corner - it measures about 1 ft x 1.5ft. It's pushed out on the outside too, so there's a draft. Can I just use strong glue and push the frame back in, or would that put pressure on the window pane and risk cracking it over time? Any other...
  5. R

    Big and deep hole/cracks above window frame.

    Hi everyone. About to paint our bedroom but there are worrying cracks/ holes above the window that I have been avoiding thinking about until now. I was going to fill them with polyfilla but having had a good look at them, they are worse than I originally thought. Any advice would be welcome...
  6. R

    Square-up window openings in block cavity walls

    Hi All, Short version: We want to replace the UPVC windows in our house and straighten the window openings through the cavity wall blockwork in the process. Our house (is the least imaginative design possible): - 9m x 9m footprint. - 2 stories with a pitched roof. - Cavity walls made of...
  7. ricky9

    Help with Burn mark on UPVC Window

    Hey there, I am having a bit of trouble with a burn mark left by an incense stick on my UPVC window. Does anyone recommend how this burn mark should be handled? Some repairers have mentioned it cannot be repaired where as others say it can. Can I repair this myself? or does anyone...
  8. V

    Openings in a old stone stable

    Hello, I am transforming a really old stone stable in Ticino (Switzerland). Since the ground floor was used for animal storage (mostly goats), it has no windows, and for the transformation I need some openings to get some light and air in. I am aware of the method of chiseling out stones from...
  9. MagMrMax

    UPVC windows won't lock in the "ajar" setting

    Does anyone have any ideas on this, please? Thanks. Moved into a house. Standard modern windows, quite new. All the windows have 2 lock positions: fully closed and "ajar" (finger-width gap allowing air in but still locked). 4 of the 10 will go into either position fine. 4 of the 10 will fully...
  10. theandroids

    UPVC Trim was hideous. What to do now?

    Good afternoon all, I removed the horrid upvc trim from around my windows to reveal these beautiful gaps.... I was going to install thinner wood trim as the trim that was put there was excessive, but I would prefer to have a flat surface rather that trim at all. Is it possible to fill with...
  11. A

    Painting over linseed oil putty

    I've putty pointed some windows using linseed oil putty. Can I paint over this type of putty using a water based paint? For the record I have some water based zinsser exterior allcoat. The putty doesn't seem to indicate anything, all it says is allow 7 days to dry before painting. It's the...
  12. A

    Original Masonry window frame - protection advice?

    Moved in to an old house that has been done up through the years. Original rough hewn masonry of window frames is still bare but is showing signs of wear with a fine crumble/dust coming off it. I'm looking in to putting a protective sealant on it before hard weather of winter comes along but...
Back
Top