Hello,
I have recently purchased on of the below bits for cutting lots of 22.5 degree angles:
https://www.routerbitworld.com/CMT-857-502-11-1-1-4-Diameter-22-5-Degree-Chamfe-p/cmt 857.502.11.htm
I am using 18mm pine wood however I need the chamfer to be the entire length of the wood. I know the bearing is supposed to go along the wood but when I try to do this I end up with a lip at the top (obviously) is there a way of doing what I need with this bit? I am going to be building quite a few octagonal tunnels and I figured that using this would make life quicker and easier. However no matter what I try with a fence or without I cant seem to get it to do what I need.
I am doing something fundamentally wrong but I cant figure out what.
Any help with this is appreciated.
James
I have recently purchased on of the below bits for cutting lots of 22.5 degree angles:
https://www.routerbitworld.com/CMT-857-502-11-1-1-4-Diameter-22-5-Degree-Chamfe-p/cmt 857.502.11.htm
I am using 18mm pine wood however I need the chamfer to be the entire length of the wood. I know the bearing is supposed to go along the wood but when I try to do this I end up with a lip at the top (obviously) is there a way of doing what I need with this bit? I am going to be building quite a few octagonal tunnels and I figured that using this would make life quicker and easier. However no matter what I try with a fence or without I cant seem to get it to do what I need.
I am doing something fundamentally wrong but I cant figure out what.
Any help with this is appreciated.
James