Adding 8XP wired to a Texecom Premier Elite 48-W

[fanch]

Adding 8XP wired to a Texecom Premier Elite 48-W



Hi all,

After installing the module, I don't see any N1 zone in the zone setup.

Confirm devices display :
Net RKP > 12..
1 EXP > 1...

View Exp. Stus display :
N1,E1 12345678
Zones HAHHHHHH

8XP connected from Network Terminal IN to PCB Layout

How do I activate the 8XP Expander Zones ?

 

[fanch]

Problem is fixed.
It was the T wire on IN terminal that was disconnected.

 

[secureiam]

Glad you found your issue and ressolved it

Only ways a keypad or expander doesn’t register

Wiring (wrong)
Power (usually not enough, long cable run)
Conflict of addresses (same address on 2 keypads or two expanders)
Interference on data lines

 

[fanch]

Thank you for the troubleshooting ways