I'm trying to plumb our washing machine in at our new house. I've attached some pictures, and I assumed that the machine pipe needs to go over the yellow pipe, which is fitted under our sink. However the waste pipe from the machine doesn't seem to fit over the yellow pipe. Am I missing a connector, or do I need to replace the existing fitting or pipe? Any advice would be appreciated, thanks!
Advice needed on how to plumb in waste pipe for a washing machine
- Thread starter R6J3H9
- Start date
Sponsored Links
- Joined
- 24 May 2016
- Messages
- 3,817
- Reaction score
- 730
- Country
Looks like it will fit. Could warm up the rubber end in boiling water then fit it with a jubilee clip. It only has to go for the first 20mm or so, I would also rotate the yellow fitting upwards.
- Joined
- 8 May 2017
- Messages
- 9,417
- Reaction score
- 2,344
- Country
Is the machines hose a loose fit ?
Or is it too small to go onto the yellow inlet ?
As said above it should point upward ,and the hose from machine should enter high up ,then point down into the yellow inlet.
Or is it too small to go onto the yellow inlet ?
As said above it should point upward ,and the hose from machine should enter high up ,then point down into the yellow inlet.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
