Hi all, this is my first post so thanks in advance for taking your time to read it.
I have just recently started to repaint a wooden surround for my fire and I'm having a few issues with the top coat of paint, would be grateful of any advice.
The wooden surround is actually mdf, I abraded the surface to remove the shine and gave it a coat if zinnser 123 primer, I followed it up with two coats of dulux undercoat and finally one coat of fortress trade satin. The satin went on about 54 hours ago but it's still not cured. The paint has dried but still feels soft, I'm guessing the top coat is a load of rubbish? If I try abrading with 600 grit the top coat will just start to come off where the paint is not hard!
Can anyone shed some light into what I am doing wrong, apologies in advance for being clueless !
I have just recently started to repaint a wooden surround for my fire and I'm having a few issues with the top coat of paint, would be grateful of any advice.
The wooden surround is actually mdf, I abraded the surface to remove the shine and gave it a coat if zinnser 123 primer, I followed it up with two coats of dulux undercoat and finally one coat of fortress trade satin. The satin went on about 54 hours ago but it's still not cured. The paint has dried but still feels soft, I'm guessing the top coat is a load of rubbish? If I try abrading with 600 grit the top coat will just start to come off where the paint is not hard!
Can anyone shed some light into what I am doing wrong, apologies in advance for being clueless !