Following on from this thread -
//www.diynot.com/forums/plumbing/no-hot-water-alpha-ocean-240p.304836/
I cant't get the boiler to stay lit, its an alpha ocean 240P. Basically after doing the refurb of the valve I was reconnecting all the electrics, when I connected the two wires just above the ignitor switch, there was a sound like a relay/contactor dropping out and the pilot light went off (had been on throughout rest of work even with mains off)
So when I got it all buttoned up, re-pressurised etc I went to relight it, and discovered I can't. Followed all starting instruction everything to off, swith to HW only and it lights fine, then when I half let the button go the HW demand led goes out and the pilot goes to what you have normally when there's no demand, but when I let it go completely it goes out!!!
Any idea's guys??
cheers
//www.diynot.com/forums/plumbing/no-hot-water-alpha-ocean-240p.304836/
I cant't get the boiler to stay lit, its an alpha ocean 240P. Basically after doing the refurb of the valve I was reconnecting all the electrics, when I connected the two wires just above the ignitor switch, there was a sound like a relay/contactor dropping out and the pilot light went off (had been on throughout rest of work even with mains off)
So when I got it all buttoned up, re-pressurised etc I went to relight it, and discovered I can't. Followed all starting instruction everything to off, swith to HW only and it lights fine, then when I half let the button go the HW demand led goes out and the pilot goes to what you have normally when there's no demand, but when I let it go completely it goes out!!!
Any idea's guys??
cheers