Buderus Boilers
- Thread starter chrisbov
- Start date
Sponsored Links
Having spoken to Bosch, I wonder if the sporadic drip could be down to the flue. This is less than a metre vertical with about 20cm horizontal to a 45 degrees angled cut end. Most others I see are vertical to a cowl of some sort. Could this open pipe allow wind to blow down the flue and cause condensate to go where it shouldn't?
Found source of drip and it was the air bleed valve. tweeked it up and it seems fine now. I was surprised by the amount of white debris in the exchanger coil and a bit annoyed to see the guy snip off about an inch of the new burner casing gasket when he replaced it during service. The manual warns against stretching it. Ho hum.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
