D
Deleted member 137318
Hi, I'm sure this question has been asked/answered somewhere but I can't seem to find much.
I have a shower tray to fit which has one of those flexiwaste devices attached to the trap - see here: http://www.toolstation.com/shop/Plu...+12+Uni+Outlet+Plain+Spigot/d20/sd2907/p75951. My problem is that I need to connect the spigot to a 40mm waste pipe. I can't find anything on Screwfix or Toolstation that will do the job, apart from maybe a 40mm Compression Straight Coupling. Would the 40mm compression tighten enough to seal around what is effectively a 38mm (1 1/2") spigot? Are there any other ways. Utopia for me would be a 1mm thick sleeve that allowed a solvent weld to take place.
Last question, why can't I just buy a 40mm flexipipe? and why are we still selling imperial fittings - OK that's 2 questions
I have a shower tray to fit which has one of those flexiwaste devices attached to the trap - see here: http://www.toolstation.com/shop/Plu...+12+Uni+Outlet+Plain+Spigot/d20/sd2907/p75951. My problem is that I need to connect the spigot to a 40mm waste pipe. I can't find anything on Screwfix or Toolstation that will do the job, apart from maybe a 40mm Compression Straight Coupling. Would the 40mm compression tighten enough to seal around what is effectively a 38mm (1 1/2") spigot? Are there any other ways. Utopia for me would be a 1mm thick sleeve that allowed a solvent weld to take place.
Last question, why can't I just buy a 40mm flexipipe? and why are we still selling imperial fittings - OK that's 2 questions