Just a quick question, can you Dab and Dot onto “hardwall” bonding , I have done a search but not found the answer .
Dot and Dab onto Bonding
- Thread starter Paul348
- Start date
Sponsored Links
yes you can, but why not skim over it?
Thanks John for your Reply, i am boarding a room out in an old cottage that has been extended at some point. Where the old bricks meet the newer there is miss-match which i think is too much to build up with “dri wall adhesive” so was going to fill it out with some bonding 1st. The area is only around 600mm x 800 so not that much. There was ordinal concrete render on their covering it all up which i have removed.
Again thanks for your reply
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
