Hi I have a ecotec pro 28 showing f75 fault when system is drained down it is still showing 1.6 bar when u press minus button boiler yet the gauge is at zero!! I have removed water sensor and cleaned all seems ok and I'm getting a good reading across it plus I have removed pump and it is working fine. I have removed where the gauge fits into behind the pump but no blockage there either! I pumped ex vessel to one bar too but it just keeps coming up f75 any ideas folks??
Ecotec pro 28 f75 fault
- Thread starter Orchard27
- Start date
Sponsored Links
It is black one already on
Sponsored Links
If its reading above 0.2 when empty put a new one in there only £20
Yes ok but I'm worried there may be a blockage somewhe
No blockage known fault just change it! U asked for advice from expert an u got it
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
