Does anyone know how to rest these switches please (Elkay Customlight 790A). The display has gone blank as if the switch has no power?
Elkay Programmable light switch
- Thread starter dstill
- Start date
I don't know anything about them but:
Does it still work to turn the light on and off?
Have you got this? See no. 4 ???
http://www.free-instruction-manuals.com/pdf/pa_359291.pdf
Does it still work to turn the light on and off?
Have you got this? See no. 4 ???
http://www.free-instruction-manuals.com/pdf/pa_359291.pdf
Has it actually got power? Check the voltage between A and C on the back of the switch.
Guys, i must apologise. After this hasn't worked for a few months I've literally just discovered the lamp that was in the light fitting must have been faulty. It didn't light up but when put in another fitting it worked for about 2 minutes then blew along with the fuse. I've put a new bulb in the light fitting connected to the Elkay switch and all is good now.
Thanks to you both for your very quick replays, it is really appreciated.
Thanks to you both for your very quick replays, it is really appreciated.
That's alright. 
sounds like one i have, as you have found out, it uses the bulb to function, Mine has to be at least 25 watt, it will not work with Led or any low energy lamps, when the bulb last failed, the display went off
It takes it's neutral from the lamp itself, so if doesn't work if the lamp blows, of if it's low-powered.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
