-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
fitting bath taps to roll top bath
- Thread starter steve1209
- Start date
For baths with taps along the side against the wall:
Before putting bath into position fit taps and pipework along the back and half way across the top end using soldered or compression elbows.
Put bath in position and join pipework to pipes in floor. Test pipework and joints to taps well before silicone sealing or tiling for obvious reasons.
Alternatively use taps that are fixed directly to wall above bath level with the pipework buried in the wall. You can then fully plumb them in and test l before positioning bath. You need to think about allowing for tiling when setting these types of taps
Before putting bath into position fit taps and pipework along the back and half way across the top end using soldered or compression elbows.
Put bath in position and join pipework to pipes in floor. Test pipework and joints to taps well before silicone sealing or tiling for obvious reasons.
Alternatively use taps that are fixed directly to wall above bath level with the pipework buried in the wall. You can then fully plumb them in and test l before positioning bath. You need to think about allowing for tiling when setting these types of taps
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
