Flashing lights on WF541 washing mashine

[malcolmandrew]

My WF541 the on/off and reduced creases lights are flashing.What does this indicate? Thanks.

 

[rocks1]

f01 light 4, motor triac
f02 light 3 motor, jammed/ tacho
f03 lights 3&4 Ntc fault
f04 light 2. pressure sw stuck on empty
f05 lights 2&4, pressure sw stuck on full
f06 lights 2&3, N/A?
f07 lights 2&3&4 heater relay
f08 light 1. heater relay
f09 lights 1&4 eprom/setup error
f10 lights 1&3, pressure switch not sensing
f11 lights 1&3&4, pump/draining error
f12 lights 1&2, communication error
f13 lights 1&2&4, dryer ntc/ fan motor
f14 lights 1&2&3, dryer heater
f15 lights 1&2&3&4, dryer heater relay
f16 N/A
f17 light 4, door lock
f18 light 3 comms error (3 phase motor) power board

f1 and f17 share the same light

 

[malcolmandrew]

Thanks for the reply but Im not sure what number corresponds to each lamp.Thanks.

 

[rocks1]

what light on the left are flashing ie 2 and 4 1 and 3 or just 4 .

 

[malcolmandrew]

The lights that are flashing are the second lamp down on the left and on/off

 

[rocks1]

error fo4. check filter and then blow though presure pipe to clear any blockage.

 

[malcolmandrew]

I have blown down pressure pipe and there seems to be no blockage and when I switched the machine on again all it seemed to do try and pump out water.After about 10 mins the on/off and second lamp down on the left started flashing again. Before the 2 lamps started flashing the "prewash" second lamp from left on horizontal row flashed for a while.
Does the Pressure switch need replacing? Thanks again for help.

 

[rocks1]

prewash flashing means no water getting in ,check hose is not kinked also the filter ,check connections on pcb are tight .

 

[malcolmandrew]

I have tried all of the things you suggested.There are no kinks and water seems to be going into machine.When I switch it back on the pump seems to be operating and I hear the water flow in to it but nothing else happens.
One thing I have noticed is the on/off and cancel buttons dont seem to have any effect when the machine is trying to function.I have to switch it off at the wall to stop it. THANKS

 

[malcolmandrew]

Do you think the pcb needs replacing.

 

[rocks1]

poss send it here http://www.emwelec.co.uk/index.php cost only a fiver to test,

 

[DAVODAVO]

I HAVE LIGHT 3 FLASHING WHICH I BELIEVE IS THE NTC ,HOW DO I REPLACE IT AND WHERE TO I GET ONE THANKS

 

[DAVODAVO]

Sorry just checked the list if only light 3 is flashing its the motor or tacho,does this mean a new motor as it seems to spin but at the wrong speeds at the wrong time or can the tach be changed?
thanks

 

[rocks1]

Check for a broken wire on the motor plug and if that's ok PCb needed.