flow rate gravity fed shower
- Thread starter rhinosaw
- Start date
Yes - try and run it all in 22mm if possible
Thanks, presume just doing the hot is ok as very little cold used.
as it gets near the shower will have to go back to 15mm cos of space, just have to hope ok.
also will it make a difference if I get a pipe bender for the elbows rather than use Speedfit push on
Thanks again
as it gets near the shower will have to go back to 15mm cos of space, just have to hope ok.
also will it make a difference if I get a pipe bender for the elbows rather than use Speedfit push on
Thanks again
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local