Hi,
I am incredibly limited in the plumbing world but happily try these things as always better to know than not so, this is my problem........
my boiler had a F9 couple of months back and got fixed under warranty, this now has run out....
it came on the other day and a chap came out, without replacing anything managed to 'reset' it with abit of checking, deciding all ok and then left.
it now reads 2.8bar on the pressure which from our chat seems way way too high...
i dont have the heating on, only used for hot water until the cold weather sets in, what can i do to bring this down if at all possible?
thank you
I am incredibly limited in the plumbing world but happily try these things as always better to know than not so, this is my problem........
my boiler had a F9 couple of months back and got fixed under warranty, this now has run out....
it came on the other day and a chap came out, without replacing anything managed to 'reset' it with abit of checking, deciding all ok and then left.
it now reads 2.8bar on the pressure which from our chat seems way way too high...
i dont have the heating on, only used for hot water until the cold weather sets in, what can i do to bring this down if at all possible?
thank you
