can any one help new gas engineer. have a glow worm micron 60ff blowing 1.5amp fuses then stopped all together. followed the fault chart no lights at all so changed pcb and hey presto its started burner lit etc great. few mins later same fault again. reset does the 10 sec fan run then thats it no lights which points to pcb again. any ideas???
glowworm micron 60ff pcb??
- Thread starter warrant
- Start date
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
