Hi, I know they do a hepvo trap inline adapter to go to 1.5inch waste pipe, do they also do a bent adapter to go to 1.5 inch waste pipe? Thanks.
Hepvo trap inline adapter/ bent adapter
- Thread starter XanderHarris
- Start date
Sponsored Links
Hep Vo's are carp when installed horizontally. Esp on showers where flow rate is low.
If at all possible use it vertically.
Hard won experience
Dreadnought
If at all possible use it vertically.
Hard won experience
Dreadnought
Sponsored Links
Do they not do a bent one that will connect to 1.5inch waste not a trap?
Never seen an elbow straight off a hep trap, what you could do if you have the space is fit the elbow on to the trap and then fit the straight adaptor into the elbow where the trap would have gone, that gives you inch and a half compression fitting each end.
No, but you could use a straight connector with a M & F elbow in
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
