Hi,
I've looked at a couple of other threads with similar problems.
The Nextra7 is not heating at all when in drying mode. I can hear the fan running though.
I took the top off and checked the thermostats - I got virtually no resistance on the two square ones (that look resettable) and something like 40-60 ohms on the one-shot round one. (all readings with the wires disconnected from them).
There's continuity through the two heater coils too.
Thanks for reading this far!
Just wanted to check:
- whether that 40-60 ohms is normal across the one-shot thermostat
- If there's anything else I should check/do
Cheers,
James
I've looked at a couple of other threads with similar problems.
The Nextra7 is not heating at all when in drying mode. I can hear the fan running though.
I took the top off and checked the thermostats - I got virtually no resistance on the two square ones (that look resettable) and something like 40-60 ohms on the one-shot round one. (all readings with the wires disconnected from them).
There's continuity through the two heater coils too.
Thanks for reading this far!
Just wanted to check:
- whether that 40-60 ohms is normal across the one-shot thermostat
- If there's anything else I should check/do
Cheers,
James
