Hi, So i have put a bathroom in down stairs (bath, toilet, sink and shower). The hot and cold supplies were tapped off with T pieces from the supplies going to the kitchen. The cold water is mains pressure and is good. The hot water from the tank has enough pressure for the bath and sink although is isn't impressive but not enough for the shower. I put a reducing valve in the cold water supply and now i get water through the shower, again far from impressive. I was thinking of a pump in the hot water supply to the whole bathroom. I have read up and it says that this pump needs its own dedicated supply from the hot water tank. Why is this? Why cant i just put the pump after the T piece that feeds into the bathroom? What would happen if i did?
Thanks in advance for any information
Thanks in advance for any information