Hi,
Hope someone can help. My dishwasher was stopping after an hour with LED 4 flashing. Searching loads of posts lead me to the conclusion that the heater was at fault so I replaced it - problem remained. Further searches pointed to the pcb and when I looked at it there was clearly some burn out damage.
So I replaced the pcb, being careful to get the right one (C00143206). I managed to get the test cycle running although the instructions I got are quite unclear. It ran for about 30 minutes and then appeared to stop with lights 2+3 flashing. From other posts, I believe that indicates a time out on fill, and when I checked carefully the inlet hose was a bit kinked. So I unkinked it and went to re-run the test cycle but I can't make anything happen at all. The lights just flash whatever button I press.
The instructions suggest it's possible to reset the cycle by holding the P button until you get three beeps but that just doesn't work. I've switched it off at the mains for 15 minutes but when I turn it back on the lights are still flashing and no amount of button pressing can get it to do anything.
Any idea what's going on?
Ian
Hope someone can help. My dishwasher was stopping after an hour with LED 4 flashing. Searching loads of posts lead me to the conclusion that the heater was at fault so I replaced it - problem remained. Further searches pointed to the pcb and when I looked at it there was clearly some burn out damage.
So I replaced the pcb, being careful to get the right one (C00143206). I managed to get the test cycle running although the instructions I got are quite unclear. It ran for about 30 minutes and then appeared to stop with lights 2+3 flashing. From other posts, I believe that indicates a time out on fill, and when I checked carefully the inlet hose was a bit kinked. So I unkinked it and went to re-run the test cycle but I can't make anything happen at all. The lights just flash whatever button I press.
The instructions suggest it's possible to reset the cycle by holding the P button until you get three beeps but that just doesn't work. I've switched it off at the mains for 15 minutes but when I turn it back on the lights are still flashing and no amount of button pressing can get it to do anything.
Any idea what's going on?
Ian
