- Joined
- 7 Jun 2023
- Messages
- 10
- Reaction score
- 0
- Country
In another thread I was helped out with wiring a timer that had been wired incorrectly.
I now realise that I need to change some cable that has gone rotten, plus one of the flex cables is just about long enough making it fiddly to wire in.
The current setup is:
Heatae Sadia Megaflo HE + a TimeGuard NTT05 timer for each immersion heater.
The cable runs from the immersion to the timer. And then another from the timer to the isolator switch (all of the cables are currently 1.5mm flex).
The questions:
- Do I replace all the cables with 1.5mm flex?
- Do I replace all with 2.5mm flex?
- Or any other combination?
I now realise that I need to change some cable that has gone rotten, plus one of the flex cables is just about long enough making it fiddly to wire in.
The current setup is:
Heatae Sadia Megaflo HE + a TimeGuard NTT05 timer for each immersion heater.
The cable runs from the immersion to the timer. And then another from the timer to the isolator switch (all of the cables are currently 1.5mm flex).
The questions:
- Do I replace all the cables with 1.5mm flex?
- Do I replace all with 2.5mm flex?
- Or any other combination?