Does anyone now the problems associated with fitting low pressure taps on a high pressure system?
I have had a problem with my boiler (Vaillant Turbo Max) tripping out when running a bath. An engineer has been to look at the boiler and after conducting tests has said the boiler is fine the problem is the taps are not letting enough water through and the heat in the water / boiler is hiting the maximum level and shutting down the boiler (it fires back up after a few seconds)
The boiler output is around 1bar and I think the taps are rated for 0.3bar; what is the impact of this? Will the taps act as a barrier?
Any ideas before I go through the expense of buying new taps?
I have had a problem with my boiler (Vaillant Turbo Max) tripping out when running a bath. An engineer has been to look at the boiler and after conducting tests has said the boiler is fine the problem is the taps are not letting enough water through and the heat in the water / boiler is hiting the maximum level and shutting down the boiler (it fires back up after a few seconds)
The boiler output is around 1bar and I think the taps are rated for 0.3bar; what is the impact of this? Will the taps act as a barrier?
Any ideas before I go through the expense of buying new taps?