I've installled a bath mixer tap with one of those shower attachments where you pull up a knob to switch to the shower. There is about 5 metres head on the hot and the cold is mains fed. When I tested this with hot only it was acceptible, but when I turn on the higher pressure cold the shower slows??? I am wondering if the cold is fighting the hot?
I considered a PEV (which seem to be around £70 so not something to buy on a whim), but worried that the shower pressure might be too low then... can you use a PEV and feed to a shower pump and them to the bath mixer perhaps?
Any thoughts/help appreciated
I considered a PEV (which seem to be around £70 so not something to buy on a whim), but worried that the shower pressure might be too low then... can you use a PEV and feed to a shower pump and them to the bath mixer perhaps?
Any thoughts/help appreciated