Ok
Thanks to some guidance on here and Heatline (although refused to go into detail as I'mnot registered which is a fair point) I am narrowing my pressure problem down by removing the above 5 inch pipe. The bit that goes into the vessel was fine (ish!) as it had a nut union. However the bit tha goes into the pressure valve housing on the top has no nut. I've been told it's a clip.(plasic) .. but i can't see it. Doesn't help it is sunk abot a 1/4 inch into the housng so it's blind ..also it's at the back.... I can get to it but can't see what I'm dealing with.
Any ideas?
Many thanks
R
Thanks to some guidance on here and Heatline (although refused to go into detail as I'mnot registered which is a fair point) I am narrowing my pressure problem down by removing the above 5 inch pipe. The bit that goes into the vessel was fine (ish!) as it had a nut union. However the bit tha goes into the pressure valve housing on the top has no nut. I've been told it's a clip.(plasic) .. but i can't see it. Doesn't help it is sunk abot a 1/4 inch into the housng so it's blind ..also it's at the back.... I can get to it but can't see what I'm dealing with.
Any ideas?
Many thanks
R
