Hi - the machine is 14 years old - I have replaced 6K1 relay and fuse four or five times over the years [big shout out to zipper for your posts on how to do that ]. Last week the machine stopped immediately after filling [instead of mid-cycle] and rinse light flashed so replaced fuse and 6K1 and also changed the brushes for the first time.
Put it on a short wash cycle with nothing in it to check if all was ok. It filled and the drum turned in both directions for a while but then stopped with flashing rinse light.
It empties ok so the pump works.
Questions please:
Why would the drum turn several times and then stop? Could my rubbish soldering cause it?
At 14 years old, is it time for a new one?!
Put it on a short wash cycle with nothing in it to check if all was ok. It filled and the drum turned in both directions for a while but then stopped with flashing rinse light.
It empties ok so the pump works.
Questions please:
Why would the drum turn several times and then stop? Could my rubbish soldering cause it?
At 14 years old, is it time for a new one?!
Last edited:
