Hopefully someone can help or provide advice.
I have mira orbis 10.8KW shower.
I had a problem where the shower would only run cold.
I identified an issue with the one shot thermal switch which was replaced nf cured the problem.
For about two weeks then the switch failed again.
Symptoms were shower started and operated ok, when the shower was turned off the water turned cold then spluttered and appeared to be steam coming out of the shower head.
I replaced the TCO but after two weeks approx the same issue.
I have a pare TCO but don't want to keep replacing switches without getting to the root cause.
Looking through previous peeps problems the issue may be the control board but I don't want to be buying components and replace and not identify the problem.
Can anyone offer advice or checks I could do to identify the issue?
The shower is about 12 months old and used every day
Thanks in advance
Russ
I have mira orbis 10.8KW shower.
I had a problem where the shower would only run cold.
I identified an issue with the one shot thermal switch which was replaced nf cured the problem.
For about two weeks then the switch failed again.
Symptoms were shower started and operated ok, when the shower was turned off the water turned cold then spluttered and appeared to be steam coming out of the shower head.
I replaced the TCO but after two weeks approx the same issue.
I have a pare TCO but don't want to keep replacing switches without getting to the root cause.
Looking through previous peeps problems the issue may be the control board but I don't want to be buying components and replace and not identify the problem.
Can anyone offer advice or checks I could do to identify the issue?
The shower is about 12 months old and used every day
Thanks in advance
Russ