- Joined
- 8 Jun 2016
- Messages
- 11
- Reaction score
- 0
- Country
I have used a single switch box. It will have a single switch in it. It is 73mm square and 48mm deep. It inserts into a hole milled in the finished face of a square aluminium extruded post approx. 4" square and 8 feet tall. The cut out is 79mm square and the LogicPlus faceplate is 86mm square. The LogicPlus faceplate are hollowed out on the back and should be able to accommodate the electrical box not being installed perfectly flush with the post face. But by how much is what I need to know.
The electrical box I have pushes as far in as it can with the bracket I have designed for it. I am pretty sure I need to design different mounting brackets that allow the box to sit further into the posts so that the box is flush with the face of the post. But as the posts are sent pre-assembled here in Canada I have to have new posts made and new brackets made with the boxes installed here and FedExed to Singapore. I was trying avoid that expense.
The electrical box I have pushes as far in as it can with the bracket I have designed for it. I am pretty sure I need to design different mounting brackets that allow the box to sit further into the posts so that the box is flush with the face of the post. But as the posts are sent pre-assembled here in Canada I have to have new posts made and new brackets made with the boxes installed here and FedExed to Singapore. I was trying avoid that expense.