Why do people mitre the beads back at the ends?
I've never done this, i've always just cut them square.
I'm curious.
I've never done this, i've always just cut them square.
I'm curious.
question about skim beads
- Thread starter kjacko
- Start date
Sponsored Links
This answer might sounds a bit daft, but cutting them back at an angle on the end, rather than square, makes them easier to fit.
Roughcaster.
Roughcaster.
C
cheadleplastering
Why do people mitre the beads back at the ends?
I've never done this, i've always just cut them square.
I'm curious.
Sometimes when fixed into position the ends bend & peel back, can be a right pain to get back straight so easiest remedy is to cut them off at an angle with the tin snips
Sponsored Links
hate it when that happens....DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
