rusty 3 way valve

[seco services]

all i can say is it sounds knacked.
if you have power in.
but no power coming out on ch/hw

 

[steve44]

thanks again for your time seco. yes off to get new programmer tomorrow and fingers crossed all will be well. Thanks for the time replying to all the bits and i know you must spend a lot of time on these q's as i have read a lot of other problems and seen yor input.good knowledge.
thanks again from steve.
p.s will keep you informed
and wont mention that i flushed a few upstairs radiators re fitted them and had the wife downstairs with buckets and bad language as it leeked through the floor. l.o.l
Steve

 

[seco services]

was it lighting up when ch/hw called for ?

 

[steve44]

morning another day..

programmer was lighting up when when heating called for,also hot water.power in but not out even when 3 way valve pushed over etc..
suspect it is deceased
thanks Steve

 

[steve44]

danfloss that's the future....out with the worn out drayton tempus 7.
got myself a ts715 si turbo...and looked at wiring diagrams for the last 3 hours....there different...any clues as to swop the 2
much help appreciated

thanks steve

 

[seco services]

who makes that ? danfoss

just found one

the ts715 is only single channel no good to you.

 

[steve44]

evening serco hope you had a good day.....poets day yahoo

danoss randall ts715 si

instruction book says could swop for my old broken drayton tempus one and two..i have a seven but am hoping 1 2 7 wiring all the same.

steve

 

[seco services]

read your manual its a single channel programmer am i correct ?

 

[steve44]

wiring conversions instructions tried to simplify

mains load
ea n l com off spare on
ea n l 1 2 3 4


for conversion from drayton tempus 1 and 2


ea n l 1 3 4 2


so in my laymans terms does it mean swop 2 for 3 3 for4 4 for 2

 

[seco services]

hold on forget the wiring
its a single channel programmer NO GOOD TO YOU.

 

[steve44]

yes definately single channel

thanks steve

 

[seco services]

thats no good then you need two channels - hw - ch.

http://randall.danfoss.com/xxTypex/287408_MNU17428113_SIT313.html

http://randall.danfoss.com/xxTypex/287387_MNU17428109_SIT313.html

both two channel

wiring easy your wall plate should be ok.

http://randall.danfoss.com/PCMPDF/FP715 Si and CP715 Si.pdf

 

[steve44]

looks like a trip to plumb centre again....thought all timers the same


not....

is there a big difference between single channel and my old drayton 7...plumb centre doing new drayton 7 so will pop in there and get replacement.


phone lines are easier to look after.decided plumbing too many different versions of the same thing....

steve

 

[seco services]

the difference is that a single channel will only do one thing
your 7 will do two things at different times. you know what i mean.

single channels ok if you what to add another heating zone.

i thought you would of just got a newer 7.
didn't they ask what you wanted ? muppets.

 

[steve44]

my local plumb centre this p.m

electrician after wireless room stat.

salesboy...all the boxes look the same do you want to come round this side and see what your after....l.o.l
and the electrician did.

so long and short...if i get a replacment drayton newer version 7

off with the old and on with the new...wiring should be the same touch wood.....coals getting low now.l.ol.....