this is a bit long winded but bear with me. I was planning to plumb a manual mixer shower in by running pipe from hwc to the hot and teeing off the cold bath tap, but after looking in airing cupboard there was absolutely no room to do anything, so i thought there seems like enough pressure at the hot tap so i will tee off that. how wrong i was. so i have acquired a pump one in one out, my question is, is it ok to put pump in a position where it will be before the tee off point so when pump is running it will be pumping for shower and bath tap. grateful for any advice
shower problem
- Thread starter jhnnegus
- Start date
Sponsored Links
showers are best supplied of their own supplies from the hw cylinder and cws tank.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
