A
angelf
I put a pcb into worcester 24i boiler . Worked fine then an hour later no light to boiler or timer? Any ideas what I can do to sort out the matter? cheers
m
m
Sponsored Links
try in the plumbing forum..
A
angelf
Ta gas4 u. But what caused the 2amp fuse to blow in the first place? Want to know in case the same thing happens again? Cheers
Sponsored Links
The most usual culprits are a water leak dripping onto an electrical connection, the fan, or the pump.
You need to check over all the components, as whatever done it, may be the cause of the pcb failure and you don't want that to happen again
You need to check over all the components, as whatever done it, may be the cause of the pcb failure and you don't want that to happen again
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
